Pair ZX064282U $24.99
¼ inch square tubing, 3 ft piece $4.25
2 - 10/32in x 1in 1 1/4in bolts with screw head with nylon ring nut (for each side)
1 - ¼ in x 1in bolt with nylon ring nut (for each side)
Remove floorboard pad.
Measure width of floorboard (approx. 4in) and length of peg from JC Whitney from nut into peg (approx. 1 ½ in).
Cut square pipe 5 ½ in long.
Drill 2 - 10/32in holes to attach to existing holes in floorboard.
Drill 1 - ¼in hole for peg bolt.
Attach cut square pipe with 2 bolts under floorboard.
Attach peg with bolt.
Hope this helps,
Questions should be asked in our forum (Use discuss link below).
The forum is very active and you stand a good chance of getting your questions
answered there. If you would like to leave feedback
for the author, or have additional information you think will benefit others, please use
the comment section at the bottom of this page.
Discuss this article on the forums. (5 posts)
This information and procedure is provided
as a courtesy and is for informational purposes only.
Neither the publishers nor the authors
accept any responsibility for the accuracy, applicability, or
suitability of this procedure. You assume all risks associated
with the use of this information. NEITHER THE PUBLISHERs NOR THE AUTHORs
SHALL IN ANY EVENT BE LIABLE FOR ANY DIRECT, INDIRECT, PUNITIVE, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES, OF ANY NATURE ARISING OUT OF OR IN ANY WAY
CONNECTED WITH THE USE OR MISUSE OF THIS INFORMATION OR LACK OF INFORMATION.
Any type of modification or service work on your motorcycle should