Reprinted by Permission of RoadStarMagazine.com
|Your clutch should be adjusted so that there is about a nickle's worth of play in the lever, when slight tension takes up the slack in the cable. NOTE: better a little loose (more than a nickel's worth of play) than too tight.
Step 1. Shows the orginal way it will look when you start and when you're done.
Step 2. Simply pull the rubber boot back to expose the locking wheel and adjustment screw.
Step 3. Loosen the locking wheel by turning it counter clockwise (when you put it back...finger tighten only...just snug it!)
Step 4. After you check the gap to see how it is, then adjust the screw to loosen or tighten the cable. If you turn the screw CCW, it will be backing out of the hole and will make the gap smaller/cable tighter. CW does the opposite (loosens the cable). If I need to tighten mine (the cable will usually get loose because it stretches), I like to put slight pressure on the lever to open the gap and watch it as I back the screw out. Then when I think I have it where I want it, I work the lever a few times to make sure it stays there. Then put the locking wheel back down.
It's not hard and it would be helpful to know how to do this for when you are on the road. I had to pull over in the middle of a parade and adjust mine, because the constant starting and stopping stretched the cable, which was new.
Bill "Sax" DeFord
Copyright © by RoadStarMagazine.com All Right Reserved.
Questions should be asked in our forum (Use discuss link below).
The forum is very active and you stand a good chance of getting your questions
answered there. If you would like to leave feedback
for the author, or have additional information you think will benefit others, please use
the comment section at the bottom of this page.
Discuss this article on the forums. (2 posts)
This information and procedure is provided
as a courtesy and is for informational purposes only.
Neither the publishers nor the authors
accept any responsibility for the accuracy, applicability, or
suitability of this procedure. You assume all risks associated
with the use of this information. NEITHER THE PUBLISHERs NOR THE AUTHORs
SHALL IN ANY EVENT BE LIABLE FOR ANY DIRECT, INDIRECT, PUNITIVE, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES, OF ANY NATURE ARISING OUT OF OR IN ANY WAY
CONNECTED WITH THE USE OR MISUSE OF THIS INFORMATION OR LACK OF INFORMATION.
Any type of modification or service work on your motorcycle should
be performed by a
If performed incorrectly,
this procedure may
endanger the safety of you and others
on your motorcycle and possibly
invalidate your manufacturer’s warranty.
Quote this article on your site | Views: 57376
Written by Newf1, on 11-30-2017 08:27
how do you adjust the shifter
|Clutch Cable Replacement|
Written by TECK, on 07-17-2009 10:55
Is There an article with step by step instructions and pictures on how to replace a clutch cable?
Written by xcopper, on 04-12-2006 19:29
I would like to oil my cables ,but i'm new at this ,do you have pictures and step by step on how to do this ? I know alot of guys out there don't know how to oil there cable's. Pictures would help. My e-mail address is email@example.com
Only registered users can write comments.
Please login or register.
Powered by AkoComment Tweaked Special Edition v.1.4.6
AkoComment © Copyright 2004 by Arthur Konze - www.mamboportal.com
All right reserved