Reprinted by Permission from Fatbike
Ixnay the Attleray
If your like most of us you've noticed right away that the gas tank seems to rattle from the rear of the tank.
Although there are many fixes out there, some may cause problems later.
In an effort to keep the stock mounting parts stock the following fix is suggested:
Simply remove the nut from the long bolt that holds the tank to the frame.
(Located at the rear of the tank. Remove the seat and you'll see it!)
Now insert rubber washers, aprox 1/16" thick between the tank bracket and the frame bracket while threading the bolt back through the brackets and the bolt collar.
(See illustration.) One on each side will do the job.
Tighten everything down and you are done.
This method is preferred over shortening the bolt and collar, primarily because the design by Yamaha calls for the tank to "float" somewhat. They didn't take into account the noise factor however. The rubber washer will allow some movement, while quelling the noise.
Total time: 10 minutes (5 minutes with practice...) Just remember that they are there when you remove the tank or you'll be chasing those buggers all over the garage! |
|
|
|
|
Questions should be asked in our forum (Use discuss link below).
The forum is very active and you stand a good chance of getting your questions
answered there. If you would like to leave feedback
for the author, or have additional information you think will benefit others, please use
the comment section at the bottom of this page.
Discuss this article on the forums. (7 posts)
DISCLAIMER:
This information and procedure is provided
as a courtesy and is for informational purposes only.
Neither the publishers nor the authors
accept any responsibility for the accuracy, applicability, or
suitability of this procedure. You assume all risks associated
with the use of this information. NEITHER THE PUBLISHERs NOR THE AUTHORs
SHALL IN ANY EVENT BE LIABLE FOR ANY DIRECT, INDIRECT, PUNITIVE, SPECIAL,
INCIDENTAL, OR CONSEQUENTIAL DAMAGES, OF ANY NATURE ARISING OUT OF OR IN ANY WAY
CONNECTED WITH THE USE OR MISUSE OF THIS INFORMATION OR LACK OF INFORMATION.
Any type of modification or service work on your motorcycle should
always
be performed by a
professional mechanic.
If performed incorrectly,
this procedure may
endanger the safety of you and others
on your motorcycle and possibly
invalidate your manufacturer’s warranty.
Quote this article on your site | Views: 28375
Written by vipertools@yahoo.com, on 07-17-2012 22:48 I recently bought my 2001 Silverado and was concerned about the noise from the left side under the gas tank. After reading this article, I used 1/16" o rings. I used four. The same day, I changed the oil to Mobil One V Twin 20-50 and the Mobil one oil filter. On my test ride I was distressed to hear another sound...it was my little Texas bell that I had never heard before. I am so relieved to get rid of the noise...thanks Fatbike.... |
Tank rattle may not be in the tank! Written by xcz5785, on 03-26-2009 18:16 After much investigation, strips of rubber under the tank and annoying rides I found my problem!! I decided to reach up and grab the headlight ring! It stopped!!! I thought for sure it was coming from the tank. A bit of electrical tape under the ring fixed it! |
Written by sonnyreyes715@yahoo.com, on 11-17-2008 13:16 i need help i want to change the fender of my roadstar and i'm leaning on the baron fenders cuz i got rearended a couple week ago is there anyone who has the baron two bob fender? |
Only registered users can write comments. Please login or register. Powered by AkoComment Tweaked Special Edition v.1.4.6 AkoComment © Copyright 2004 by Arthur Konze - www.mamboportal.com All right reserved
|