Hello everyone, well here they are at last, adjustable floorboard extensions for the Road Star (and possibly other models) Water jet cut from 3/8" plate steel and powder coated gloss black. New hardened M10X1.25 bolts, new hardened washers and new nylock nuts will accompany each shipment. These extensions will allow you to move the floorboards forward from 2 1/2 inches to 3 1/4 inches and adjust the angle from 7 degrees to 15 degrees of tilt.

This setup is for 99-03 models


This setup is for 04 and newer models


I was able to negotiate a slightly lower cut charge on the pieces and I also searched and found my hardware at a somewhat lower price through another supplier, consequently I have a slightly lower price point to pass on to you all.

The Adjustable Floorboard Extensions are now priced at $75.00 SHIPPED to the lower 48 states!

PREFERRED payment is paypal, however if you need to or would like to pay another way, I am flexible.

***** I was going to start selling these with auctions for the first 2 sets, with 100% of the auction winnings of both being donated back to the Clinic in the form of FastJohnnys Grandson and the other for jberenyi's son Travis' seat. But since there didnt seem to be that much interest, the first 2 sets sold will have 100% all $75.00 from each set donated to each of the above. *****

Thank you for your interest,
Rod

Hey Rod,

Any idea if they will fit with the barons crash bar or am I screwed?

Those are nice looking. If I hadn't bought a set from billjr about 5 or 6 years ago I'd be on those in a heartbeat!

Chefturner wrote:
Hey Rod,

Any idea if they will fit with the barons crash bar or am I screwed?

They fit well with the Yamaha Big Bar, I have not been able to test with any other bars to check for the fit. You can be the first If they absolutely wont fit, you being a "test subject" I will gladly refund you if they dont

Rod

Rod if you take a look at my signature pic, you can see that the bar sits literally a half inch directly in front of the floorboards. and has a pretty big slant cut to it. I am curious if you think the extensions will raise the boards enough to come up over the bar. I can get you some dimensions tonight.

Chefturner wrote:
Rod if you take a look at my signature pic, you can see that the bar sits literally a half inch directly in front of the floorboards. and has a pretty big slant cut to it. I am curious if you think the extensions will raise the boards enough to come up over the bar. I can get you some dimensions tonight.

I hate to discourage sales, however I dont see the floorboards being able to clear your bar even moved forward the minimum amount with the maximum angle. If you would really like to move your floorboards forward for a more comfortable position, I see no other way than to remove the bar or replace it with a different one.

Rod

Unfortunately I had a feeling you might say that.

Is this a Baron's bar?



Know it's not a Yami big bar. What's left? Stock setup right now.

greyphart wrote:
Is this a Baron's bar?



Know it's not a Yami big bar. What's left? Stock setup right now.

As far as I can see, no that is not a Barons bar. If you look in the post above at Chefturner's sigpic you can see how close his bar is to the floorboard. Looks like you have plenty of room to move them from what is seen in your photo's.

Rod

If that's the case put me down for a set. I'll PM you when I'll be ready for them. Thanks!